Buy New and Used Van and Car parts

Find best value great quality parts at cheap prices for your car, van and 4X4s HERE!

Not sure of reg or non-UK reg? Enter make and model here

Not sure of reg? Enter Make and Model manually

Find any Van or Car Part for free, Saving time and Money £££

Find parts now

1Enter your Registration

2Select what parts you want

3Buy parts now or get free personalised quotes

Check our right part guarantee and see how your money is secure when purchasing on Breakeryard.com

Used Rover Anti Roll Bar Bushs

All used Rover Anti Roll Bar Bushs listed on Breakeryard.com are tested, original (OEM) manufacturer parts and come with a 14 day money back guarantee. Breakeryard.com list cheap new OES or aftermarket car parts at discounted prices and used OEM car parts up to 80% cheaper than main dealer prices for Rover from premium breaker yards from across the UK.

About Anti Roll Bar Bushs

A Rover anti roll bar bush is an essential part of the suspension system of a vehicle. The job of the anti-roll bar is to balance movement of the vehicle when cornering and minimising side to side movement, preventing the vehicle from leaning or rolling over. It is particularly useful in high wind situations. These are fitted on the front and rear of the suspension.

The bushes on an anti-roll bar are made of a strong rubber and secure the anti-roll bar in place. They are always fitted to the front suspension of the vehicle, but it’s becoming more common for them to also be fitted to the rear suspension too. They take a large amount of strain from the forces of the anti-roll bar. This means that over time they will wear thin and become less effective or crack and dry out through use. They’re also subject to disintegration if they come in to contact with oil.

It’s recommended that Rover anti-roll bar bushes are checked and replaced regularly. Both sides should be replaced at the same time as if one bush is damaged, its pair will most likely be damaged too.

Rover trivia

  • MG Rover sold all of its key assets to the Nanjing Automobile Group in 2007 after going into administration.
  • In 2003, MG Rover released the CityRover. It didn't sell anywhere close to expectations, and the car company started to seriously struggle as a result.
  • During the 1960s, Rover was forced to cancel several promising car projects. That's because Rover became a corporate partner with Jaguar, and some of the projects they were working on were too similar! The Rover P8 was just one of the victims of this partnership and a prototype was never built.
  • The iconic logo of Rover is a Viking longship. Currently, the rights to using that logo are in the hands of the Jaguar Land Rover group.
  • Although there were a few Rover-made cars released in the ‘80s, none of them had the word Rover on any of the badging. Instead, they were called Austins, but they did have a similar, Viking-inspired badge.